Product ID: EV-9270-70
H-300 Water Filter system Features
- Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor and chloramines.
- Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and sulfides. - As tested by Everpure.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
- Adsorbs common earthy, moldy, fishy tastes and odors.
- Reduces lead to below the Federal Action Level of 10 ppb.
- Effectively reduces Volatile Organic Chemicals (VOCs), including Trihalomethanes (THMs).
- KDF Media reduces limescale buildup in water-using appliances - As tested by KDF Fluid Treatment, Inc.
- KDF Media provides bacteriostatic control - As tested by KDF Fluid Treatment, Inc.
Health Claim Performance Certified By NSF/ANSI
This system has been tested according to ANSI/NSF 42 and 53 for the reduction of various substances. The concentration of the substances in water entering the system was reduced to a concentration less than or equal to the permissable limit for water leaving the system, as specified in ANSI/NSF 42 and 53.
Operating Specifications
- Capacity: 300 gallons (1,135 L).
- Pressure requirement: 10-125 psi (0.7 - 8.6 bar), non-shock.
- Temperature: 35-100 degrees F (2-38 degrees C).
- Flow Rate: 0.5 gpm (1.9 Lpm).
General Installation Requirements
- Space required: 5 x 5 x 20 in. including 2-1/2 inches of clear space under unit for cartridge change.
- Install vertically with cartridge hanging down.
- Use minimum length of tubing possible.
- Flush new cartridge at full flow for three minutes to purge air.
- Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually. MSRP: $415.99
Our Price: $ 332.79 (back) |
Product ID: EV-9282-00
H-1200 Water Filter system Features
- Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor, chloramines and other bad tastes and odors.
- Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and sulfides.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
- Adsorbs common earthy, moldy, fishy tastes and odors.
- Reduces lead to below the Federal Action Level of 10 ppb.
- Effectively reduces Volatile Organic Chemicals (VOCs), including Trihalomethanes (THMs).
- Effectively reduces methyl tertiary-butyl ether (MTBE).
- Inhibits limescale buildup in water-using appliances - As tested by KDF Fluid Treatment, Inc.
- KDF Media inhibits microbial growth - As tested by KDF Fluid Treatment, Inc.
- Provides bacteriostatic control with KDF media - as tested by KDF Fluid Treatment, Inc.
Health Claim Performance Certified By NSF/ANSI
This system has been tested according to ANSI/NSF 42 and 53 for the reduction of various substances. The concentration of the substances in water entering the system was reduced to a concentration less than or equal to the permissable limit for water leaving the system, as specified in ANSI/NSF 42 and 53.
Operating Specifications
- Capacity: 1,000 gallons (3,780 L).
- Pressure requirement: 10-125 psi (0.7 - 8.6 bar), non-shock.
- Temperature: 35-100 degrees F (2-38 degrees C).
- Flow Rate: 0.5 gpm (1.9 Lpm).
General Installation Requirements
- Install vertically with cartridge hanging down.
- Use minimum length of tubing possible.
- Flush new cartridges at full flow for three minutes to purge air.
- Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually. Price: $553.50 (back) |
Product ID: EV-9252-66
H-54 Water Filter system Features
- Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor.
- Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and sulfides.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
- Adsorbs common earthy, moldy, fishy tastes and odors.
- Reduces lead to below the Federal Action Level of 10 ppb.
- Inhibits limescale buildup in water-using appliances - As tested by Everpure.
Health Claim Performance Certified By NSF/ANSI
This system has been tested according to ANSI/NSF 42 and 53 for the reduction of various substances. The concentration of the substances in water entering the system was reduced to a concentration less than or equal to the permissable limit for water leaving the system, as specified in ANSI/NSF 42 and 53.
Operating Specifications
- Capacity: 750 gallons (2,839 L).
- Pressure requirement: 10-125 psi (0.7 - 8.6 bar), non-shock.
- Temperature: 35-100 degrees F (2-38 degrees C).
- Flow Rate: 0.5 gpm (1.9 Lpm).
General Installation Requirements
- Space required: 5 x 5 x 20 in. including 2-1/2 inches of clear space under unit for cartridge change.
- Install vertically with cartridge hanging down.
- Use minimum length of tubing possible.
- Flush new cartridge at full flow for three minutes to purge air.
- Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually.
*NOTE* The H-54 system requires that you have a water shutoff valve and a separate faucet for the filtered water. We can supply the faucet but not the valve. Price: $311.18 (back) |
Product ID: EV-9262-70
H-104 Water Filter system Features
- Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor.
- Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and sulfides.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
- Adsorbs common earthy, moldy, fishy tastes and odors.
- Reduces lead to below the Federal Action Level of 10 ppb.
- Inhibits limescale buildup in water-using appliances - As tested by Everpure.
Health Claim Performance Certified By NSF/ANSI
This system has been tested according to ANSI/NSF 42 and 53 for the reduction of various substances. The concentration of the substances in water entering the system was reduced to a concentration less than or equal to the permissable limit for water leaving the system, as specified in ANSI/NSF 42 and 53.
Operating Specifications
- Capacity: 1,000 gallons (3,780 L).
- Pressure requirement: 10-125 psi (0.7 - 8.6 bar), non-shock.
- Temperature: 35-100 degrees F (2-38 degrees C).
- Flow Rate: 0.5 gpm (1.9 Lpm).
General Installation Requirements
- Space required: 5 x 5 x 20 in. including 2-1/2 inches of clear space under unit for cartridge change.
- Install vertically with cartridge hanging down.
- Use minimum length of tubing possible.
- Flush new cartridge at full flow for three minutes to purge air.
- Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually. Price: $322.65 (back) |
Product ID: EV-9273-75
ROM II Water Filter system Description: The ROM II utilizes the S-101 carbon block pre-filter to reduce chlorine tastes and odors and other particulate matter in the water. The system’s Thin Film Composite (TFC) reverse osmosis cartridge then filters the water down to .00001 microns. This method of filtration reduces contaminants such as arsenic, lead, copper, sodium, nitrates, fluoride, cysts and TDS. The ROM II offers additional features, such as: - Reduction of lime and scale build-up in appliances that use water
- More efficient filtering, which requires less frequent cartridge change
- Fresh water on demand
- A lower operating cost that is below the price of bottled water
The ROM II also: - Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor.
- Reduces dirt, rust, asbestos fibers and other particulates such as oxidized iron, manganese and sulfides.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba and Cryptosporidium.
- Controls even extreme levels of common “off” tastes and odors, including those that are earthy, moldy and fishy.
- Reduces lead to below the Federal Action Level.
- Is certified by NSF/ANSI in the reduction of arsenic, barium, cadmium, chromium, copper, fluoride, lead, nitrate/nitrite, selenium, radium, cysts, sodium and chloroform.
The ROM II features a normal production rate of 14.4 gallons per day at a 1/2 gallon per minute flow rate. Reverse Osmosis Systems
All RO systems work more effectively at higher water pressures. System comes with a 3 gallon storage tank, Air Gap Faucet, installation kit, and John Guest T. Price: $674.25 (back) |
Product ID: EV-9273-75
ROM III Water Filter system Description: The ROM III employs the same water filtering capabilities as the ROM II, but adds another level of protection against volatile organic chemicals and MTBE that may exist in the water. This method of filtration also reduces contaminants such as arsenic, lead, copper, sodium, nitrates, fluoride, cysts and TDS. The ROM III offers additional features, such as: - Reduction of lime and scale build-up in appliances that use water
- More efficient filtering, which requires less frequent cartridge change
- Fresh water on demand
- A lower operating cost that is below the price of bottled water
The ROM III also: - Finely polishes treated water to premium quality for drinking and cooking.
- Reduces chlorine taste and odor.
- Reduces dirt, rust, asbestos fibers and other particulates such as oxidized iron, manganese and sulfides.
- Reduces parasitic protozoan cysts such as Giardia, Entamoeba and Cryptosporidium.
- Controls even extreme levels of common “off” tastes and odors, including those that are earthy, moldy and fishy.
- Reduces lead to below the Federal Action Level.
- Effectively reduces VOCs, including trihalomethanes (THMs).
- Effectively reduces methyl tertiary-butyl ether (MTBE).
- Inhibits limescale build-up in water-using applications.
- Is certified by NSF/ANSI in the reduction of arsenic, barium, cadmium, chromium, copper, fluoride, lead, nitrate/nitrite, selenium, radium, cysts, sodium, MTBE, VOCs and chloroform.
The ROM III features a normal production rate of 14.4 gallons per day at a .5 gallon per minute flow rate. Reverse Osmosis Systems
All RO systems work more effectively at higher water pressures.
System comes with a 3 gallon storage tank, Air Gap Faucet, installation kit, and John Guest T. Price: $749.25 (back) |
Product ID: EV-9370-00
T-20 Water Filter system Description: All too often, common impurities make ordinary tap water undesirable for cooking, drinking and bathing. Chlorine, sulfur and even metal piping can add unpleasant tastes and odors. A T-20 Filter can easily solve these problems and, at the same time, supply bottled-quality tap water. You'll find meals and beverages will have a truer flavor because your water will be free from the off-tastes and odors which can alter the flavor of prepared foods.
Contaminant Reduction Efficiency | Chlorine | 90 - 99% | | Fishy, musty, earthy tastes & odors | 90 - 99% | | Visible Particles such as dirt & rust --larger than 40 microns | 99.9% | | Invisible particles that can make water hazy -- sub-micron to 40 microns | 99.9% | | Entamoeba histolytica, Giardia lambila cysts | 99.9% | | Asbestos fibers | 99+% |
T-20 Water Filter Specifications | MICRO-PURE Re-Charge | # 2053 | | Diameter | 8.75 in (22.2 cm) | | Height | 28.5 in (72.4 cm) | | Required Vertical Space | 32 in (81.3 cm) | | Required Horizontal Space | 10 in (25.4 cm) | | Pipe Size (Inlet & Outlet) | .75 ln. unions | | Maximum Temperature | 100°F (38°C) | | Filtration Rating | 1-2 microns | | Pressure - Max. | 125 psi (8.8 kg/cm2) | | Pressure - Min. | 20 psi (1.4 kg/cm2) | | Flow Rate | 4 gpm | | Shipping Weight | 21 lb. (9.6 kg) |
Price: $1510.88 (back) |
|